#1 2014-03-02 10:27:01

mack_turtle
Member
Registered: 2013-07-28
Posts: 5

southwest Austin (Broadie/Davis) to downtown

I am buying a house in the neighborhood, just a few blocks from Dick Nichols Park, and I plan to ride to work downtown most days. it should be about ten miles. I am sure there are a few possible routes and I am not timid in traffic, but I would like the most direct route that is reasonably safe. any ideas? I would want to get into town through Lamar.

Offline

#2 2014-03-02 13:31:28

savanni
Member
From: Austin
Registered: 2011-04-30
Posts: 82
Website

Re: southwest Austin (Broadie/Davis) to downtown

I used to live there and biked the same thing.  This is the route that I used:

http://goo.gl/maps/GM8rE

About 8.5 miles, and Brodie is about the only busy street you're on.  Brodie has had good bike lanes for a couple of years, and is otherwise abnormally wide.  Taking Lamar directly instead of the Bouldin Creek neighborhood cuts off about one mile.

Offline

#3 2014-03-02 13:40:07

Tom Thayer
Newbie
Registered: 2014-03-02
Posts: 1

Re: southwest Austin (Broadie/Davis) to downtown

Depending on where you are exactly, you can take Beckett (bike lanes) to Convict Hill to Brodie if you live west of MoPac.  Convict Hill bike lanes end near the library and the road is narrow two lanes for part of the way, but traffic is not too bad.  If you live east of MoPac, you can just take neighborhood streets to Brodie.  Once on Brodie, there are bike lanes all the way to Sunset Valley.  Right before the Home Depot stoplight, you can turn right into the alley that goes behind the shopping center and take it to Ernesto Robles.  Turn right on Ernesto Robles to Jones Rd and take Jones Rd across Westgate to Packsaddle Pass.  Turn left and Packsaddle Pass turns into Victory Dr where it goes under Ben White.  Then turn left on Panther Tr and you will be at S Lamar.  Jones Rd doesn't have bike lanes but is fairly comfortable for riding, not too much traffic.  Packsaddle Pass is basically a neighborhood street.

Offline

#4 2014-03-02 16:14:13

Donald Lewis
Member
Registered: 2009-07-11
Posts: 184

Re: southwest Austin (Broadie/Davis) to downtown

You can also turn off of Brodie on Lovegrass before the shopping center and cut through to Ernest Roble on a nice little empty park trail.  Just look for the pedestrian/cyclist bridge on the left just after turning off Brodie.

Don in Austin

Offline

#5 2014-03-03 12:06:57

Jack
Member
Registered: 2013-03-27
Posts: 344

Re: southwest Austin (Broadie/Davis) to downtown

savanni wrote:

I used to live there and biked the same thing.  This is the route that I used:

http://goo.gl/maps/GM8rE

About 8.5 miles, and Brodie is about the only busy street you're on.  Brodie has had good bike lanes for a couple of years, and is otherwise abnormally wide.  Taking Lamar directly instead of the Bouldin Creek neighborhood cuts off about one mile.

My route is a bit straighter.  Still pleasant.  http://goo.gl/maps/5ZlPq

Last edited by Jack (2016-05-04 15:27:40)

Offline

#6 2014-03-03 22:59:12

Donald Lewis
Member
Registered: 2009-07-11
Posts: 184

Re: southwest Austin (Broadie/Davis) to downtown

More variations:  http://www.mapmyride.com/routes/view/366588271

Slightly longer but absolute minimum of traffic. Much of this ride you can go several blocks without encountering a moving car.  You have to carry bike across R tracks at one point:  http://www.mapmyride.com/routes/view/366589303

Don in Austin

Offline

#7 2014-03-03 23:17:42

mack_turtle
Member
Registered: 2013-07-28
Posts: 5

Re: southwest Austin (Broadie/Davis) to downtown

thanks for the routes folks!

I should add that I am a pretty confident cyclist and I don't mind taking some dirt trails and busy roads if needed. I just want to avoid any suicidal roads. I am also thinking of taking my mountain bike some time and riding to the Greenbelt and riding singletrack part of the way. that might be more work than it's worth just to get to work but it could be fun.

Offline

#8 2014-03-04 00:02:25

dougmc
Administrator
Registered: 2008-06-01
Posts: 631

Re: southwest Austin (Broadie/Davis) to downtown

And while I'm not really going to suggest it as a good idea, but it should be mentioned: the direct, hardcore route.

Get to Convict Hill and Mopac, carry your bike over the barrier and get into the Mopac turnaround, and take Mopac north.  Stick to the frontage roads, but you'll have to take the lane on Mopac proper as you go over the greenbelt and you're mingling with 65 mph traffic.  That part is only 0.6 miles long, and it's slightly downhill so you can easily do 40 mph, but it ruins what would otherwise be a reasonably acceptable route -- the frontage roads on Mopac aren't too bad.  After that, you just stay on Mopac's frontage roads until you hit Barton Springs.

That said, if you want to go mountain biking, I imagine you could just go down into the greenbelt before that point.  It would be slower, but no cars.

This would shave several miles off the routes that others have given you, depending on exactly where you want to go.  (For example, I live right near Dick Nichols and work at Barton Skyway and Mopac.  If I take that route to work, it's right at six miles total.  If I take the routes the others have mentioned, it's around 12-13 miles.)

The city is building a pedestrian bridge there -- they just started construction a few weeks ago -- but it's still at least a year away from completion.  I imagine once that's done, they'll put in bike lanes or something else along the entire route.  There's also a trail that's being built or planned, called the Violet Crown trail, that will pretty much go from Dick Nichols to Barton Springs, but I don't know what the timescale is for that or what it'll be like or what.

For the return trip, over the greenbelt is a lot less hairy, as you have a shoulder, but the frontage roads are a little more hairy than they are on the other side (but still nowhere near as bad as the 0.6 miles over the greenbelt.)

Offline

Registered users online in this topic: 0, guests: 1
[Bot] ClaudeBot

Board footer

[ Generated in 0.017 seconds, 9 queries executed - Memory usage: 548.49 KiB (Peak: 549.12 KiB) ]